Notifications
Clear all
Topic starter
23/10/2019 6:51 am
Sup All i just recieved a vial of Test Cyp from Dragon Pharma. It appears that most of the particles have frozen to the bottom of the vial, i have an unfrozen vial which im going to start with first, but should i just let it thaw or what?
23/10/2019 7:49 am
Sounds like it crashed...common and no big deal. It is due to high
concentration with low BA and hitting cold temps. Simply stick a pin in the stopper (not letting it make contact with the gear) and bake at 250 for 10 minutes - Take it out, remove the pin and shake it up. You'll be good to go
23/10/2019 8:15 am
you can bake it like suggested above or you can fill up a pot with some water about half way up the vial & then warm it on medium for about 20minutes...be sure to stick a pin in the top of it so the pressure wont build up in the vial...this is should fix your problem...
*Disclaimer*: 'GiantKilr' is a fictitious character with the sole purpose to entertain & theorize on the use of Anabolic Steroids for intellectual discussion. Any information or advice given out, stated, or implied by 'GiantKilr' is for entertainment purposes only & should not be considered the advocation of any illegal activity.
Topic starter
23/10/2019 8:35 am
warm it as in on top of a stove?
23/10/2019 8:57 am
basically putting the vial into warm/hot water to get the crystals back into solution.
Using a stove and a pot of water is a means of doing so.
Do not try to microwave, and do not cook it.
And as the others said above, the pin is to let expanding pressure (caused by heating the vial) escape.
I have heard people saying to remove the pin a few seconds after removing the vial from heating. (Supposedly this causes the cooling environment inside the vial to create a suction, and that is also supposed to help the test stay in solution.)
Anyone feel free to correct me, just helping out.
Peace!
23/10/2019 9:20 am
warm it as in on top of a stove?
yup, fill up the pot to about half way up the vial & then heat on medium for about 20min & that should fix your problem...you shouldnt have to do this again but you can do this over & over if you have to...
*Disclaimer*: 'GiantKilr' is a fictitious character with the sole purpose to entertain & theorize on the use of Anabolic Steroids for intellectual discussion. Any information or advice given out, stated, or implied by 'GiantKilr' is for entertainment purposes only & should not be considered the advocation of any illegal activity.
Topic starter
23/10/2019 9:41 am
cool thanks bros