Notifications
Clear all
Questions About Steroids
5
Posts
4
Users
0
Reactions
482
Views
Topic starter
16/10/2022 2:25 pm
Just curious, but I like to do quad injections using a 1" 25 gauge pin. Since oil is difficult to push through the small gauge pins I usually pull the tip off my syringe and set it in a coffee mug in my microwave for about 15 seconds to warm up the oil. After the heat up it goes through the tiny gauge pins easily even when I used Tren. My question, does this hurt the chemical in any way? I'm talking a very small amount of time just to heat up the oil.
16/10/2022 2:52 pm
i like to run the syringe under hot water for a minute. a little more controlled i think. I have heard of people doing the microwave technique, just dont do it for too long.
Topic starter
16/10/2022 3:23 pm
Maybe I'll try the hot water. I think that is what someone told me to do initially but the shitty apartment I lived in at the time had warm water so it didn't work well at all.
16/10/2022 3:42 pm
I do the hot water in a cup thing.. works for me..
16/10/2022 4:03 pm
since the oil comes out slow i think it makes for a better injection. this way you know you're taking your time as opposed to doing fast injections. just my opinion.